GRAPHTEC CSX500 Series - Handling Documents According to Their Material and Thickness

3-5
3.3 Handling Documents According to their Material and Thickness
The following problems may occur, depending on the thickness and surface condition of the document
being scanned.
• The document cannot be loaded.
• Scanning of the document stops half-way through.
• The document slips (resulting in displaced images).
• The end of the document is not scanned.
Such problems may be avoided by taking the following corrective measures.
<Adjust the scanning speed>
Adjust the scan speed using the table below as a guide and following the steps.
(1) Start up the “Scanning Master Pro Color (OPS115)” software that is provided with your scanner,
and then display the [Scan] screen.
(2) Select the [Document] tab to confirm the set "Resolution (DPI)."
(3) Next, select the [Options] tab, and then move the “Scan Speed” slider to the confirmed resolution
position.
"Scan Speed" settings guide (set in the "Scanning Master Pro Color ‘OPS115’")
Note: When “Quality” is set to “High quality” and “Output” is set to “Grayscale” in "Scanning Master
Pro Color ‘OPS115’"
These values are suggested as a guideline only. The actual values will vary according to the
type of document and its condition.
Model Document
Thickness
(mm)
Resolution (dpi)
200 300 400 600 800 1200
CSX510-09 0.65 to 0.8
Position of the
below figure (2)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
0.8 to 1.6
Position of the
below figure (4)
Position of the
below figure (3)
Position of the
below figure (4)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
CSX530-09 0.65 to 0.8
Position of the
below figure (5)
Position of the
below figure (5)
Position of the
below figure (4)
Position of the
below figure (5)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
0.8 to 1.6
Position of the
below figure (7)
Position of the
below figure (6)
Position of the
below figure (6)
Position of the
below figure (5)
Position of the
below figure (6)
Position of the
below figure (1)
(Standard)
CSX550-09 0.65 to 0.8
Position of the
below figure (6)
Position of the
below figure (6)
Position of the
below figure (6)
Position of the
below figure (5)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
0.8 to 1.6
Position of the
below figure (8)
Position of the
below figure (8)
Position of the
below figure (8)
Position of the
below figure (8)
Position of the
below figure (1)
(Standard)
Position of the
below figure (1)
(Standard)
“Scan” screen
Slider position
(1) (2) (3) (4) (5) (6) (7) (8)