1-4
1.3 Assembling the Scanner
Please see the separate Stand Assembly Instruction Manual for instructions on how to assemble the
stand.
Attaching the document support plates
Always be sure to install the document support plates, irrespective of the type of documents to be
scanned.
(1) Take one of the document support plates provided, and insert its hooks into the slots at the rear of
the scanner. Insert the hooks from the top of the slots.
Document support plateHooks
(2) Attach the other document support plates in the same manner.
Checkpoint
Detach the document support plates when moving or packing the scanner. Lift the plates
up and out of the slots to detach them.
Attaching and using the cable clamp
Attach the cable clamp to the scanner, and then pass the power cable, USB cable and network cable
(CSX550-09 only) through the clamp to fasten them in place.
Caution
Be sure to attach the cable clamp to the scanner and use it to fasten the power cable,
USB cable and network cable (CSX550-09 only) in place. Failure to do so may affect the
scanning operation.
Attaching the clamp
(1) Using a soft cloth that has been soaked in water or diluted neutral detergent and then firmly wrung
out, wipe off any dust or dirt on the surface of the attachment location before attaching the cable
clamp.
Cable clamp attachment location
To Next Page
Loading...
