2-18
2.7 Network Connection (CSX550-09 only)
Caution
Both USB and network connection cannot be executed simultaneously. Please refrain
from connecting the USB cable and the network cable to a single computer at the same
time.
Checkpoint
• The procedure outlined below is based on the requirement that you are logged on to
Windows with administrator rights. Consult your Windows manual and Windows Help for
more information.
• Before executing Graphtec Network Utility, please be sure to first install the scanner
driver software. (see Section 2.5, “ Installing the Scanner Driver Software”)
Installation procedure
The following procedure assumes that you are using the Scanner connected via a Network interface
as part of your system.
The windows shown are those for Windows 7.
(1) Turn on the Scanner and computer power, and connect to a Network interface.
(2) Insert the "IMAGE SCANNER USER GUIDE CD-ROM," which came with the scanner, into the
CD-ROM drive.
AutoPlay screen will appear shortly. Select [Run MultiSetup.exe] from there.
(3) The User Account Control screen is displayed. Click [Yes] to proceed with the installation.
To Next Page
Loading...
