3-4
• Load the document in the scanner with the surface to be scanned face up.
• Do not place anything other than the document to be scanned on the documentscanning
table. If you do so, the scanner rollers may start rotating, which is extremely dangerous.
• The document may not be fed in correctly if it is curled. The carrier sheet should be used
for curled documents (see Section 3.5, “Using the Carrier Sheet” for details).
• Load the document in the center of the scanner, as the document may be fed in at an
angle and not scanned correctly if it is significantly off-center.
• Load the document in the center of the scanner. If it is significantly off-center, the
document may shift and may not be scanned correctly.
To Next Page
Loading...
