2-8
(5) The screen shown below appears. Click the [Next] button
(6) The screen shown below is displayed. Click [Install] to proceed with the installation.
(7) The screen shown below is displayed when the wizard has finished installing the driver. Click the
[Finish] button to close the “Device Driver Installation Wizard”.
(8) Turn on the scanner, and then the scanner connects to the computer.
(9) The following message appears on the taskbar when you connects to the scanner. Wait for the
driver installation is finished. (It may take several minutes.)
Checkpoint
• If the computer is not connected to the network, the installation finishes immediately,
and the message from the next step [10] appears on the screen.
• If the computer is connected to the network, this message may disappear during the
installation. In this case, wait until the message from the next step [10] appears on the
screen.
• The following screen appears when you click the message. In this case, by selecting
the "Skip obtaining driver software from Windows Update" link the installation can be
finalized early.
To Next Page
Loading...
