2-14
(6) The screen shown below is displayed when the wizard has finished installing the driver. Click the
[Finish] button to close the “Device Driver Installation Wizard”.
(7) Turn on the scanner, and then the scanner connects to the computer.
(8) When the following screen appears, Select the option “No, not this time” and then click [Next].
(When Service Pack 2 or later has been installed, the following screen may appears.)
(9) The following screen appears. Select the option “Install the software automatically
(Recommended).” and then click [Next].
(10) The screen shown below is displayed. Read the explanation and make sure that you understand
the contents. To continue the installation, click [Continue Anyway].
To Next Page
Loading...
