2-21
(9) When the following screen appears, select the scanner displayed on the “Search result overview”,
and click [Next].
Note: The Ethernet address cannot be found at the back of the product.
Note: If the scanner is not displayed, confirm that the scanner is connected to your computer, and
click [Search].
Caution
• If the IP address has been set to a setting other than the initial setting (0.0.0.0), the IP
address of the computer used to make the setting must belong to the same subnet as
the IP address that was set for the scanner.
• This setting cannot be made if there is an existing IP address that is the same as that of
the scanner.
• When the setting will be performed from a location that a router is used to access,
depending on the type of router used, there may be locations that cannot be searched.
In this case, make the setting within the same segment.
(10) This will calibrate your IP address settings.
Note: Depending on the environment, the screen displayed may vary.
• In case the following screen is displayed:
Select “Assign IP Address”, and then click the
[Next] button after entering your desired IP
address.
Note: If you don’t know your IP address,
please ask your network manager. If
there exist 2 or more of the same IP
address on one network, the network
may be damaged.
• In case the following screen is displayed:
Specify your desired IP address, and then
click [Next].
Note: If you don’t know your IP address,
please ask your network manager. If
there exist 2 or more of the same IP
address on one network, the network
may be damaged.
To Next Page
Loading...
