GRAPHTEC FC7000-160 - Recommended Parts List; FC7000-75;100;130;160 Parts

FC7000-UM-251-9370 2-6
2. PARTS NAMES and FUNCTIONS
(4) Mount the plotter on the stand by inserting the positioning pins on the stand into the positioning holes
on the underside of the plotter. Fasten with four socket head cap screws (two on each side), using the
Allen wrench.The cutting plotter mounting direction is different for the front loading and the rear loading
models.
Socket head
cap screws
Positioning pin
Socket head
cap screws
Caster stoppers
Positioning pin hole
<Front loading>
<Rear loading>
(5) Tighten the socket head cap screws loosely fastened in Step 2.
• Check that all of the screws used for fastening have been tightened. The media
may not be fed correctly if even one of the screws is loose.
• When installing the plotter, make sure that there are no objects in its vicinity.
Leave a clear space of at least 300 mm around the plotter.