9-2 9-3
Interface Setting Menu
Setting of the interface condition is only necessary when the plotter is connected using network (LAN) or RS-
232C cables.
It is not necessary when the plotter is connected using the USB cable.
P.9-3
Connecting with Network (LAN)
P.9-6
Connecting with RS-232C
Connecting with Network (LAN)
*
If the network (LAN) setting is changed, the settings of the plotter will be reset.
Next page
1
Press the [MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION (
▲
) key.
INTERFACE setting screen (1/3) is displayed.
3
Press the POSITION (
▼
) key.
INTERFACE setting screen (2/3) is displayed.
Supplement
It will return to INTERFACE setting screen (2/3)
without changing the settings when you press
the POSITION (
◄
) key (CANCEL).
MAC address is displayed when the POSITION
(
►
) key is pressed.
l
l
4
Press the [2] key (LAN).
LAN setting screen is displayed.
To Next Page
Loading...
