1-9
Mounting the stock rollers
Insert the stock rollers into the slots on the media stocker.
<Front loading>
Stock rollers
<Rear loading>
Stock rollers
Front
Attaching the FC8600 Basket
The basket is attached directly to the plotter.
The basket is made up of the following parts.
Basket x 1, basket tubes (long) x 3, basket tubes (short) x 4, joints x 4, mounts x 2, socket cap head screws x
4, use Allen wrench to assemble the basket.
Be sure to use the basket when cutting long-axis media of more than 2 meter is to be produced.
Cloth basket Basket tube (long) x 3
Socket head cap
screw
(M5) x 4
Mount x 2
Basket tube (short) x 4
Joint
x 4
To Next Page
Loading...
