Settings and Measurement
3-7
2. SPAN/TRACE/POSITION
Switches the display in the digital display.
Used to change the settings related to waveform display during Free Running
(when stopped), data capture, and data replay.
Pressing this key will switch displays as shown below.
3. TIME/DIV
Press the TIME/DIV key to change the time axis display range.
This key is inoperative in the X-Y screen.
Displays digital values
(default status)
Allows changing of the span
value (waveform amplitude)
• Channel change: CHSELECT keys
• Amplitude change: keys
• Change range: 8 voltage levels
/6 temperature levels
Allows changing of the position
(waveform up/down position)
• Channel change: CHSELECT keys
• Amplitude change: keys
• Change range: In steps of 10% of
the range
Allows turning ON/OFF of
the waveform display
• Channel change: CHSELECT keys
• Amplitude change: keys
• Change range: ON/OFF
* At OFF, data is captured all the same.
MONITOR SPAN POSITION TRACE
* When ALL is set, setting values for CH1 is reflected on other channels.
When CH1 is OFF, ALL cannot be set.
To Next Page
Loading...
