3-14
Settings and Measurement
3.3 Operation Modes
You can check the system operation status in the simplified message display.
Operation status transition
(1) Free Running
When in Free Running status, you primarily set up the system to capture data.
You can check the current input signal as a waveform or digital values.
Operations available during Free Running
ReplayingCapturing
Capturing and Replaying
Free Running
[
REVIEW
]
key
[
START/STOP
]
key
When capture ends, the screen
automatically switches to the
replay screen.
[
QUIT
]
key
[
REVIEW
]
key
[
START/STOP
]
key
* Data cannot be replayed just after
power-on or no data has yet been
captured.
Measuement parameters settings
The MENU key is used to change various setting items in configuration menus.
SPAN/TRACE/POSITION The SPAN/TRACE/POSITION key is used to change settings.
Display mode The DISPLAY key is used to change the display mode.
File operations The FILE key is used to perform file-related operations.
Replay of last data (captured last time)
The REVIEW key is used to replay captured data.
Data replay The FILE key is used to select data that you want to replay and replay it.
Operation
Free Running
Capturing
Capturing and
Replaying
Replaying
Operation
Start up status or data is not being
captured
Data is being captured in the main
memory or USB device.
Data being captured is being replayed
Captured data is being replayed
Operation
Free Running
Capturing to Internal RAM, Capturing to Internal Flash
Memory, Capturing to USB memory
Capturing and Replaying
Replaying from Internal RAM, Replaying from Internal
Flash Memory, Replaying from USB Memory
To Next Page
Loading...
