GRAPHTEC GL900 - Menu; Quit (Local); Direction Keys

3-8
Settings and Measurement
4. MENU
Open the settings window to capture data. For details on settings, see Section
3.4, "Setting Menus" on page 3-17.
5. QUIT
The key is primarily used for the following operations.
• To cancel a setting during menu configuration.
• To return to the MONITOR window when the SPAN/TRACE/POSITION
window is displayed.
• To cancel remote status (in which keys are disabled) through interface control.
• To close the menu screen.
• To quit data replay.
• To return from the Enlarged Waveform, Digital + Calculation Display, or X-Y
screen to the Waveform + Digital screen.
6. Direction keys
These keys are primarily used for the following operations.
• To move in a menu or between setting items during menu configuration.
• To move the cursor during replay.
• To move the active channel in the Waveform + Digital screen or X-Y screen
( and keys).
• To change the setting of SPAN/TRACE/POSITION ( and keys).
• To change the quick settings ( and keys).
• To change the setting of the channel to be allocated in the X-Y screen ( and
keys).