GRAPHTEC GL900 - Setting Menus

Settings and Measurement
3-17
3.4 Setting Menus
When you press the MENU key during Free Running, the following menu screens appear.
The menu screens are classified by the tab for each setting item.
(1) AMP settings
This menu is used to specify input signal-related settings.
<Analog settings> <Logic and Pulse settings>
AMP DATA TRIG OPT OTHR
Setting Selections available
Input Off, Voltage, Temperature, Humidity
Range [Voltage] 20, 50, 100, 200, 500 mV; 1, 2, 5, 10, 2
[Temperature] TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S
Filter Line, A5, 50, 500Hz
EU Function Off, On
(Scaling Measured Upper limit value Numeric value input
settings) value Lower limit value Numeric value input
EU output Upper limit value Numeric value input
value Lower limit value Numeric value input
Decimal point 1, 10, 100, 1000, 10000
Unit selection Current, length, area, volume, speed, acceleration, frequency,
weight, power, pressure, flow, temperature
Unit (Selections vary depending on the selected units listed in the above.)
User-defined unitText input
Misc. Span Upper limit value Numeric value input
setting Lower limit value Numeric value input
Annotation setting Text input (11 characters max.)
Perform Auto Zero ADJ. Execute
Reset Auto Zero ADJ. Execute
Logic and Pulse Off, Logic, Pulse
[Logic] Off, On
[Pulse] Input Off, Revolution counts, Counts, Inst.
Filter Off, On
Slope
↑
H,
↓
L
EU Function Off, On
Measured value Numeric value input
EU output value Numeric value input
Unit selection Current, length, area, volume, speed, acceleration, frequency,
weight, power, pressure, flow, temperature
Unit (Selections vary depending on the selected units listed in the above.)
User-defined unit Text input
[xxx] shows a case in which xxx is selected from available selections.