3-18
Settings and Measurement
Switching displays
Analog and Logic/Pulse can be switched as shown below.
Analog settings
This screen allows you to set conditions for analog signals.
CHECKPOINT
ALL and Span All Settings are set only for the currently displayed group (per 10 channels).
(1)-1 Input
Selects input conditions.
(1)-2 Range
Specifies the range of signal input to be measured.
• Display Logic/Pulse Data
A screen switches
with ENTER key.
• Display Analog Data
Selection Description
Off Disables the measurement of input signals and the waveform and digital display.
Voltage Used for measuring direct-current voltages.
Temperature Used for measuring temperatures.
Humidity Used for measuring humidity with humidity sensor B-530.
This selection sets the voltage range to 1V and disables EU settings.
Input setting Selection
Voltage 20, 50, 100, 200, 500mV; 1, 2, 5, 10, 20, 50, 100, 200, 500V; 1-5V
Temperature TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S, TC-N, TC-W,
Humidity No selection
To Next Page
Loading...
