Settings and Measurement
3-21
(1)-5 Misc.
Logic and Pulse settings
Specifies the digital input settings.
(1)-6 Logic/Pulse
Selects the digital input processing method.
(1)-7 Input
Sets the pulse measurement mode. This item can be set only when Pulse is selected in (1)-6.
(1)-8 Filter
Sets the filter for digital input.
Setting Description
(1) Span Sets the upper and lower limits of the span in which waveforms should be
displayed.
(2) Annotation Sets an annotation (comment) to be displayed for each channel.
The annotation can be 11 characters long at the maxim
um.
You can use alphanumeric and kana characters and symbols.
(For details on text input, see page 3-41.)
(3) Perform Auto Zero ADJ Performs calculation using the current input voltage as the zero position
voltage value.
(4) Reset Auto Zero ADJ Cancels the zero position voltage value and displays the input voltage.
(5) [Zero Position Voltage Value] Displays the zero position voltage value (display only).
Setting Description
Off Disables the measurement of digital input.
Logic Digital input is processed as logic signals.
Pulse Digital input is processed as pulse signals.
Setting Description
Off Disables the pulse input.
Revol. Counts the number of pulses per second and and multiplies it by 60 to capture an rpm value.
Counts Captures the cumulative number of pulses for each sampling interval from the start of measurement.
Inst. Captures the number of pulses for each sampling interval.
Setting Description
Off Disables the hardware filter.
On Enables the hardware filter. The filter is effective in an environment where there is lots of noise.
Filter is approximately 30 Hz (-3dB).
To Next Page
Loading...
