Installation
152 Planning and Installation Manual
6. Refer to the Jupiter VM-3000 System Controller Installation and
Operation Manual, part no. 071 8305 xx or the Jupiter CM-4000
System Controller Installation and Operation Manual, part no. 071
8261 xx for control system installation details.
Note Newer-model Trinix units have “1-based” input/output connector num-
bering; i.e., there is no connector “0.” However, Jupiter tables are always
0-based. When controlling such units, references to Physical Input/
Output connectors in Jupiter tables refer to that connector number plus
1. E.g., Physical Input 10 in the Jupiter Switcher Input table would cor-
respond to connector number 11 on the Trinix rear panel.
To Next Page
Loading...