Analog Input Processing
210 Planning and Installation Manual
7.) Save or Recall a Configuration File
This selection allows a setup to be saved on the PC and recalled. For
example, if a particular source requires a video level correction, a
file named “VTR3_in7_vid_gain” could be downloaded when
needed.
To Save a File On PC
This procedure assumes that video adjustment(s) have been made
(as described above) and need to be saved for future use.
a. Select “Save or Recall a configuration file.”
b. Select “Save a configuration file to the PC.”
Response:
Prepare your terminal emulator to receive (upload) data now...
c. For Hyper terminal, select “Transfer > Receive File.”
d. Create or browse to a directory on the PC where the file will be
stored.
Suggestion: “c:\Program Files\Thomson\Trinix\VI-33100.”
e. Select Xmodem for the protocol. Then select “Receive.”
f. Enter a filename where the data will be saved on the PC.
Suggestion: “config1.”
Note If you enter the name of an existing file the software will automatically
append a number suffix and save the file under the new name.
g. Select “OK.”
To Recall a File From PC to VI Board
a. Select “Save or Recall a configuration file.”
b. Select “Recall and LOAD a configuration file from PC.”
Response:
Prepare your terminal emulator to send (download) data now...
c. For Hyper terminal, select “Transfer > Send File.”
d. Browse to the desired configuration file on the PC.
e. Select “Xmodem” for the protocol. Then select “Send.”
To Next Page
Loading...
Need help?
General
