131
Programming examples – Fixed-wing models
»Free mixers« (page 102)
… and set, say, LinearMIX 2 to “S to Ch1”. On the se-
cond page of the menu set a symmetrical mixer input
of +100% once more.
If a switch is not assigned to this mixer, it delivers a
constant, non-switchable signal to control channel 1
(see page 107), which keeps the speed controller at
its OFF position. (If this is not reliably the case, you
will need to correct the travel and / or direction appro-
priately.)
Finally you have to set this second mixer to “no” in
the «Normal» phase of the »MIX active/phase«
menu. (When you switch between the two fl ight pha-
ses, only one of the two mixers will ever be active.)
If you have set up everything correctly, the Ch1 stick
only controls the motor in the «Normal» fl ight phase,
but the motor is switched off in the «Landing» fl ight
phase (servo 1 in »Servo display« to -100%). In this
fl ight phase the Ch1 stick only operates the wing fl aps
(ailerons up, fl aps down), with a neutral point in the
forward position of the Ch1 stick.
If the model also features airbrakes, these can be in-
cluded by setting up a third mixer (e.g. “Ch1 to 8”),
which is only active in the landing fl ight phase.
To Next Page
Loading...