45 / 48
S1042_sh_V1
• Finally you will be asked to switch the transmitter on: push the
MODE button on the mz-10 HoTT transmitter while you switch
it on. Release the MODE button as soon as the transmitter has
been recognized: "Found target device ...".
• The data transfer to the transmitter begins. During the update
on the transmitter the LEDs light on: CH2, CH3, BIND and 2AILE.
• The end of the data transfer will be indicated by the update pro-
gram. The transmitter indicates the end of the transfer though
the power on melody.
• Switch off the transmitter and interrupt the USB connection to
the PC.
• After each update, check if the model functions are correct.
To Next Page
Loading...
