27 / 48
S1042_sh_V1
Range warning
In general, an acoustic range warning is emitted once the receiver
signal in the feedback channel becomes too weak. Since the trans-
mitter's output is significantly higher than the receiver, the model
can always be operated safely. For safety reasons however, the model
distance should be reduced until the signal silences.
If the acoustic warning signal does not quit in spate the reduced dis-
tance, the use of the model should be interrupted immediately and
the transmitter should be checked. Eventually the transmitter's
under-voltage or receiver's temperature warning are active. Then
the battery should be charged or the receiver temperature should
be checked.
Note
In case the transmitter cannot set a connection to a proper back
channel or during the use an existing connection is interrupted, the
transmitter mz-10 HoTT BIND LED turns off and the buzzer indicates
it with a 4 times beep signal (back channel missing), after that with
a 3 times beep following (transmission interference to the receiver).
Contemporaneously the status LED blinks 3 times.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
