16 / 48
S1042_sh_V1
Neutralizing the control sticks
Neutralizing step by step
Locate in the left control stick gimbal the screw surrounded by a
white circle in the picture.
Turn the screw toward the inside of the transmitter until the relevant
control stick can move freely from stop to stop, or turn it outward
until the control stick resets itself independently.
Note
The right control stick gimbal is specular to the left one, so that here
the screw is located left under the middle.
Brake spring and ratchet
The outboard screw of the two marked in the figure adjust the brak-
ing force.
The inboard screw adjusts the strength of the ratchet for the respec-
tive control stick.
Note
The right control stick gimbal is specular to the left one, so that here
the screws are located right on the top side.
Control sticks centering force
The control sticks' restoring force can also be adjusted. The adjust-
ment is located next to the return springs.
By turning the respective adjust screw the spring force can be
adjusted:
Right turn = return harder
Left turn = return softer
Note
The right control stick gimbal is specular to the left one, so that here
the screws are located left in the middle.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
