S1006.PRO_mz-24_PRO_EN USA_V1 21 / 34
For this example, SW5 is assigned to flaps by toggling the switch on the
radio to record it to CH5
CH5 which is your flap channel can now be operated with SW5. In most
cases we would like to have the flaps move slowly into position to reduce
sudden attitude changes which can be done with slowing them movement
down a bit.
Press NEXT twice which will bring you to the channel slow menu.
Add a delay for example of 1.2s on CH5 which will slow the movement of
that channel with 1.2 seconds.
If you want to see how any of the channels are responding to inputs press
the SERVO button on the screen which will show the servo monitor screen.
Move your controls to view an animated view of all of your channels.
This concludes the basic setup of your model. You can assign additional
switches or setup your fail safe and timers all done from the BASE menu.
For more advanced options, you can go to the FUNCTION MENU where
you can setup flight modes, dual/triple rates and more.
To Next Page
Loading...
Need help?
General
