4 - 14
4.6 ADJUST DIRECTION CONTROL PEDAL
IMPORTANT: Correct adjustment of the direction
control pedal is necessary to prevent severe damage
to the hydrostatic transmission.
To adjust pedal (Figure 6):
1. Remove bolt connecting rod end to direction
control weldment.
2. Adjust rod end until pedal is at an angle which is
comfortable for the operator. Turn rod end
counterclockwise to move pedal angle toward
operator and clockwise to move pedal angle away
from operator.
3. Replace hardware holding rod end to direction
control weldment.
4. Adjust control pedal stop bolts.
To adjust pedal stop bolts (Figure 7):
1. Adjust control pedal to comfortable position as
above.
2. Set forward stop bolt so pedal hits bolt at full
forward stroke.
Figure 6
1. Direction Control
Pedal
2. Rod End
3. Direction Control
Weldment
OF1511
1
2
3
Figure 7
1. Pedal (Neutral Position)
2. Forward Stop Bolt
1
2
OF1480
To Next Page
Loading...
