38
To pause the scanner on an active object so that the scanner does not
resume scanning, press the PAUSE key while the scanner is stopped on
that object, and press PAUSE or SCAN to resume scanning. Alternatively,
you may press MAN to monitor an active object. Although PAUSE and
MAN both stop the scanner on the active object, there are some small
differences in how they operate. PAUSE pauses the scanner but keeps the
scanner in scan mode, resulting in faster stop/start operation. MAN stops
scan mode completely, and allows you to browse the file system to select
other objects to monitor.
While the scanner is Manual Mode, you can browse through the stored
objects in your scanner and select one object to monitor. Use the
5
and
6
keys on the 5-way pushbutton pad to scroll through the objects assigned
to the current Scan List. The
3
and
4
keys on the 5-way pushbutton pad
are used to browse up and down through the Scan Lists, respectively. Only
Scan Lists that contain objects are shown when browsing. A quick low-high
wrap beep is played when the scanner reaches the last occupied Scan List
and wraps back to the beginning.
When the scanner is stopped on a TGRP while scanning, or paused in
Manual Mode, the display will appear as follows:
When the scanner is stopped on a conventional channel while scanning, or
while paused in Manual Mode, the display will appear as follows:
To Next Page
Loading...
