90
TLO=FUNC L/O Yes or No
Controls the operation of the L/OUT
key. When No, pressing L/OUT per-
forms a Temporary Lockout of the se-
lected object. When Yes, pressing L/
OUT performs a Permanent Lockout of
the selected object.
DupeChecksSQ Yes or No
If s et to Yes , dupe c heck ing wi ll
check both the stored frequency and
any encoded squelch settings when
checking for duplicate CONV objects.
TGID Format
N o r m , DE C o r
HEX Selects TGID display format
TGRP Ignore Yes or No
If set to Yes, TGRP wildcards will ignore
calls on previously stored TGRPs that
are mapped to disabled Scan Lists.
ShowCCInfo Yes or No
For Motorola systems, shows current
control channel index (from TSYS fre-
quency list) and frequency alternating
with the voice frequency.
Set password SEL
Enters power-on password for use this
scanner.
CONV Menu Reference
The CONV menu is used when creating new Conventional Channel objects,
or editing existing Conventional Channel objects. All menus are shown
in the scanner's display as a three line window that can be scrolled up or
down to access the various different parameters. The active parameter is
always the middle parameter and is indicated by a flashing “
:
”. The entire
CONV menu is shown below:
CONV Parameter Options Description
Scan Lists
O n o r O f f f o r
Scan Lists 01-22
Sets membership in Scan Lists. Use
34
keys to scroll through Scan Lists.
Use SEL key to toggle Scan List mem-
bership. A “
*
” next to the Scan List
number indicates that the object is
mapped to that Scan List.
To Next Page
Loading...
