89
Color 0-7
Red/Green/Blue
(RGB) value
Sets intensity of red, green and blue
LEDs. Press SEL to edit colors. Use
34
keys to scroll to R, G or B LED
settings. Use numeric keys to activate
preset intensity levels for each LED, or
use
56
keys to fine scroll intensity.
Qtxt1-0 Text value
Sets QTXT (QuickText) 0-9 text. Use “$”
to indicate end of text.
Key Repeat On or Off
Toggles key repeat mode when a key
is held down
LCD BlinkOff 1-250 x 10 mS
For alternating text displays, sets the
display time for the secondary display
element.
LCD BlinkOn 1-250 x 10 mS
For alternating text displays, sets the
display time for the primary display ele-
ment.
LED BlinkOff 1-250 x 10 mS
When the ALERT LED setting for an ob-
ject is set to Flash, this is the amount of
time the LED stays turned off.
LED BlinkOn 1-250 x 10 mS
When the ALERT LED setting for an ob-
ject is set to Flash, this is the amount of
time the LED stays turned on.
Pri Channels 0-250
Number of priority CONV channels to
check during a priority scan sampling.
“0” samples all CONV priority chan-
nels.
Pri Interval 2-100 x 100 mS
Conventional frequency priority sample
interval.
TGRP Pri Int On or Off
Toggles priority interrupt scanning du-
ring trunked calls
QuickPriRtn On or Off
When on, does not wait for verification
of correct CTCSS, or DCS when return-
ing to an active CONV channel after
priority sampling
Search Delay 1-100 x 100 mS
Sets wait for reply delay for all search
modes
To Next Page
Loading...
