88
Atten Mode Global or Normal
The attenuator reduces the amount
of signal at the receiver input. This
helps reduce interference from strong
nearby transmitters. Global attenuator
mode applies attenuation radio-wide,
regardless of individual object set-
tings. In Normal attenuator mode, the
attenuator follows the individual object
attenuator setting.
Global Atten On or Off
When the ATTEN mode is set to Glob-
al, this controls whether the Global at-
tenuator is on or off.
Clear Hits SEL Press SEL to clear all hit counters.
Hit Counts Yes or No Turns the hit counter feature on or off.
Dflt ScanList 0-22
Sets default destination Scan Lists
for new objects and CONV Stor from
Searches, Spectrum Sweeper and
Tune. Use 1-20 for “normal” Scan Lists
1-20. Use 0 for the “ns” (not scanned)
Scan List (no Scan List mappings are
specified). Use 21 for the FAV Scan
List. Use 22 for the SKYWARN Scan
List.
Priority On or Off
Turns Priority Scan On or Off. Priority
Scan can also be toggled by pressing
FUNC PRI while scanning.
WxPri
Each WX frequen-
cy or Off
Turn off the weather priority. Or, select
weather priority frequency then the
scanner watches selected weather
alert signal.
Scan Lists SEL
Enters sub menu for Scan List settings
and status
SRCH L/Outs SEL
Enters sub menu for review, editing or
deletion of search lockout frequencies
Clear FAV SEL
Press SEL to clear the Favorites Scan
List.
Memory Info SEL
Press SEL to see the current memory
usage. Use
5
and
6
keys to scroll.
EXPERT BELOW
Tune LED On or Off
Activates Signal Strength driven LED
when in TUNE mode.
To Next Page
Loading...
