Grecom PSR-410 - Initializing Global Parameters to Factory Defaults; Initializing the Scanner to Factory Defaults

83
Initializing Global Parameters to Factory Defaults
If your scanner does not appear to be functioning properly, you can reset
the global radio parameters to their factory state without losing any of your
programmed data. Any custom changes you have made to the radio's
global parameters will be lost.
NOTE: This procedure preserves the information you stored in the
scanner's working memory, while resetting all global radio parameters to
factory defaults.
1. Turn off the scanner, then turn it on again. The scanner displays
Welcome/Owner screen.
2. Press 0 while the scanner is displaying the Welcome/Owner screen. The
scanner displays
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 2. The scanner displays
Init GLOB data
To factory state
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays
GLOB EEPROM area
Initialized to
defaults.
Press any key.
5. Press any key on the keypad to proceed. The scanner will reboot with
file system and global parameters reset to factory defaults.
Initializing the Scanner to Factory Defaults
If initializing the global parameters to factory defaults does not resolve
your problem, you may wish to initialize the entire scanner to factory
defaults. This operation will result in the clearing of your programmed data
and the loss of any custom changes you have made to the radio's global
parameters. Use this option as a last result.