Grecom PSR-410 - LTR Home Repeater AutoMove; Priority Scan

60
should check every control channel in the TSYS frequency list for activity
when the TSYS is processed (
Check all CC=YES
), or check only
one new control channel for activity, incrementing to the next control
channel each time the TSYS is processed (
Check all CC=NO
).
Press the
SAVE
softkey to save your changes to the TSYS parameters,
then press the
SAVE
softkey again to use the scanner.
You should experiment with the different Multi-site modes and the threshold
settings to find a combination that works best for your location. Keep in
mind that the threshold settings are only available when
Multi-Site
Roam
is selected.
Multi-site functionality is not available in EDACS or LTR trunking.
NOTE: It may be necessary to change the values used for Threshold Hi and
Threshold Low in the TSYS object to optimize Multi-site Roam performance.
LTR Home Repeater AutoMove
LTR Home Repeater AutoMove takes the guesswork out of programming
LTR trunking systems when the home repeater order is not known.
By default, LTR Home Repeater AutoMove is turned off and is controlled
in the individual TSYS objects. To enable LTR Home Repeater Automove,
access the menu for the desired TSYS, then scroll down to the last item in
the menu,
AutoMove HRs
. Use the
34
keys to toggle AutoMove HRs
on or off for the selected TSYS, then press the
Save
softkey to save your
changes.
When AutoMove HRs is turned on, you may enter the LTR system
frequencies in any order, and the PSR-410 will automatically move the
frequencies to the proper home repeater slots as transmissions are received
on the system.
Priority Scan
Your PSR-410 scanner features Priority Scan operation for CONV and TGRP
objects. When Priority Scan is active, increased priority is given to objects
that have their Priority mode set to ON.
Turning Object Priority On or Off
Priority for CONV and TGRP objects can be toggled on or off using the
following methods: