84
NOTE: This procedure clears all information you stored in the scanner's
working memory, AND resets the global parameters to factory defaults.
Initialize the scanner only when you are sure the scanner is not working
properly.
1. Turn off the scanner, then turn it on again. The scanner briefly displays
the Welcome/Owner screen.
2. Press 0 while the scanner is displaying the Welcome/Owner screen. The
scanner displays
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 1. The scanner displays
Factory Init
Erase Memory
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays
Initializing the
File System
Please Wait.....
Then,
File System
Initialized to
Defaults.
Press any key.
5. Press any key on the keypad to proceed. The scanner will next display:
GLOB EEPROM area
Initialized to
defaults.
Press any key.
6. Press any key on the keypad to proceed. The scanner will reboot with file
system and global parameters reset to factory defaults.
To Next Page
Loading...
