103
Atten On or Off
When on, applies 20 dB of attenua-
tion to all hits received on the SRVC
search. Useful in areas where interfer-
ence from nearby strong signals is
present.
Delay On or Off
Controls whether a Delay is used to
wait for reply traffic after a transmis-
sion on the SRVC search.
Delay Time 1-200
Sets the amount of time (in 100 milli-
second intervals) for the wait for reply
delay if Delay is On, e.g., 20=2 se-
conds.
Zeromatic On or Off
When on, enhances the scanner’s
ability to lock on to the actual center
frequency of a search hit instead of an
adjacent frequency.
Search Dir Up or Down
Sets search direction used when
SRVC object is active.
Hit Count Numeric value
Increments each time a transmission is
received on the SWPR object. Global
“Hit Counts” must be set to ON. Press
the
Dfl
t softkey to reset to 0.
SWPR Menu Reference
The SWPR menu is used when creating new Spectrum Sweeper objects,
or editing existing Spectrum Sweeper objects. All menus are shown in the
scanner's display as a three line window that can be scrolled up or down
to access the various different parameters. The active parameter is always
the middle parameter and is indicated by a flashing “
:
”. The entire SWPR
menu is shown below:
SWPR Parameter Options Description
Scan Lists
On or Off for Scan
Lists 1-22
Sets membership in Scan Lists. Use
3 4
keys to scroll through Scan
Lists. Use SEL key to toggle Scan
List membership. A “
*
” next to the
Scan List number indicates that the
object is mapped to that Scan List.
To Next Page
Loading...
