91
Freq
Any supported
f r e q u e n c y i n
MHz
The frequency that the CONV object
will use.
Tag
Alpha-numeric
text
The alphanumeric display name for
the CONV channel. Use the standard
text entry method or QTXT to name the
object.
Sq Mode
Search, None,
CTCSS, DCS
Sets subaudible squelch mode. Use
Search to automatically analyze sig-
nals to determine squelch mode and
code. Use None to ignore subaudible
squelch. Use CTCSS for tone coded
squelch, or DCS for digital coded
squelch. Used in conjunction with
Squelch Code parameter below.
Squelch Code
Search, CTCSS
tone, DCS Code,
n/a
Sets CTCSS tone, or DCS code de-
pending on Sq Mode setting. Use
Search to detect tone or code value for
selected squelch type.
L/Out On or Off
Permanent lockout for the CONV chan-
nel. Also accessed by pressing FUNC
L/OUT while the scanner is stopped
on the CONV object.
Priority On or Off
Turns Priority Mode on or off for the
CONV object.
LED Mode Solid or Flash
Controls whether the ALERT LED
flashes or remains on solid when the
ALERT LED is used.
LED Color 0-7
Sets LED color to 0-7 as defined in the
GLOB menu. By default, 0=LED Off,
1=Red, 2=Yellow, 3=Green, 4=Cyan,
5=Blue, 6=Magenta, 7=White.
Latch LED On or Off
Normally the ALERT LED is active only
while the object is receiving a trans-
mission. When Latch is on, the ALERT
LED will remain lit after the transmis-
sion is complete, unless overridden by
a subsequent object that is also using
the ALERT LED.
To Next Page
Loading...
