92
Backlight On, Off or Flash
Controls whether the backlight should
be on, off or flashing while the object
is active. “Off” setting is ignored by the
PSR-410.
Alarm
None, Chirp, Hi-
Lo, Alert, Ring,
2-Chirp, Fast Hi-
Lo, DTMF#
Sets the Audible Alarm for the CONV
object. When an Audible Alarm is se-
lected, the selected alarm will play at
the beginning of each transmission
on the CONV object, or anytime the
scanner stops for activity on the CONV
object while scanning.
Fav Yes or Nof
When Yes, the CONV object is a mem-
ber of the Favorites Scan List.
Skywarn Yes or No
When Yes, the CONV object is a mem-
ber of the Skywarn Scan List.
EXPERT BELOW
Modulation
AM , FM, NFM,
Auto
Modulation setting for the CONV chan-
nel. In most cases Auto will work fine.
Use AM to override and force AM mod-
ulation, FM to force FM modulation,
NFM to force narrow FM modulation.
Atten On or Off
When on, applies 20 dB of attenua-
tion to all transmissions on the CONV
channel. Useful in areas where inter-
ference from nearby strong signals is
present.
Delay On or Off
Controls whether a Delay is used to
wait for reply traffic after a transmission
on the CONV channel.
Delay Time 1-200
Sets the amount of time (in 100 mil-
lisecond intervals) for the wait for reply
delay if Delay is On, e.g., 20=2 sec-
onds.
AudioBoost On or Off
Applies a 6 dB boost to audio levels
when the object is active
Hit Count Numeric value
Increments each time a transmission is
received on the SWPR object. Global
“Hit Counts” must be set to ON. Press
the
Dflt
softkey to reset to 0.
To Next Page
Loading...
