94
LED Mode Solid or Flash
Controls whether the ALERT LED
flashes or remains on solid when the
ALERT LED is used.
LED Color 0-7
Sets LED color to 0-7 as defined in the
GLOB menu. By default, 0=LED Off,
1=Red, 2=Yellow, 3=Green, 4=Cyan,
5=Blue, 6=Magenta, 7=White.
Latch LED On or Off
Normally the ALERT LED is active only
while the object is receiving a trans-
mission. When Latch is on, the ALERT
LED will remain lit after the transmis-
sion is complete, unless overridden by
a subsequent object that is also using
the ALERT LED.
Backlight On, Off or Flash
Controls whether the backlight should
be on, off or flashing while the object
is active.
Alarm
None, Chirp, Hi-
Lo, Alert, Ring,
2-Chirp, Fast Hi-
Lo, DTMF#
Sets the Audible Alarm for the TGRP
object. When an Audible Alarm is se-
lected, the selected alarm will play at
the beginning of each transmission
on the TGRP object, or anytime the
scanner stops for activity on the TGRP
object while scanning.
Fav Yes or No
When Yes, the TGRP object is a mem-
ber of the Favorites Scan List.
Skywarn Yes or No
When Yes, the CONV object is a mem-
ber of the Skywarn Scan List.
EXPERT BELOW
Delay On or Off
Controls whether a Delay is used to
wait for reply traffic after a transmis-
sion on the TGRP.
Delay Time 1-200 x 100 mS
Sets the amount of time (in 100 mil-
lisecond intervals) for the wait for reply
delay if Delay is On, e.g., 20=2 sec-
onds.
AudioBoost On or Off
Applies a 6 dB boost to audio levels
when the object is active
To Next Page
Loading...
