35
and the controller will back to the parameter setting page; while by touching “Cancel”, this
setting will not be saved but the controller will back to the parameter setting page.
[Notes]
1)For the parameters with different defaults under different conditions, when the constraint
(like, unit type) changes, the parameter will back to the default value under the corresponding
condition.
2)When setting for the current parameter is unavailable, “N/A” will be displayed.
)3The numerical keypad includes digits from “0~9”, “-“, “.”,”OK” and the backspace key.
4)When the input value is out of the setting range or accuracy of the input value is
inconsistent with that of the rated, continuous input will fail or there will be corresponding alert,
and also the input value will be automatically deleted.
See the table below for the user parameters.
No Full Name
Displayed Name
1
Entering water temperature for cooling Entering water-T for cooling
2
Entering water temperature for heating Entering water-T for heating
3
Leaving water temperature for cooling Leaving water-T for cooling
4
Leaving water temperature for heating Leaving water-T for heating
5
Start temperature for E-heating Start-T for E-heating
6
End temperature for E-heating End-T for E-heating
4.5.4 Information
Operation Instructions
(1)At the menu page, by touching “INFO.”, the control panel will go to the following page.
A Series Modular-type Air-cooled (Heat Pump) Chiller
To Next Page
Loading...
