51
corresponding setting page. Then, by touching “Program information”, the controller will
access to the program checking page, as shown in the figure below.
[Notes]
“Version” indicates the program version for the control panel.
4.5.7 Setup of Toggle Switches on the Motherboard
Five-bit toggle switches are used for indicating hardware address (1~16) of modules, with
module No. displayed in turn on the panel as Module 1, Module 2, ……, Module 16. Toggle
switches 1,2,3,4 and 5 are binary codes, with 1 for the lowest bit and 5 for the highest bit.
Comparison drawings are as follows (Caution: only in the condition of power supply shutoff
can toggle switches be set):
A Series Modular-type Air-cooled (Heat Pump) Chiller
To Next Page
