Gree FLEXX Series

GREE DC INVERTER HEAT PUMP CONDENSING UNIT
74
Removal of compressor/gas liquid separator
NOTE: Before removing the compressor/gas liquid separator, make sure there is no refrigerant in the pipeline and power is cut off.
Step
Picture
Work instruction
2. Break off the pipes that
connecting to the
compressor/gas liquid
separator.
 Weld the pipes that are
connected to the
compressor/gas liquid
separator.
 Then remove the pipes.
NOTE: When welding the
pipes, do not let the flame
burn the other
components.
3. Loosen the compressor’s
base connectors / gas
liquid separator’s base
nuts.
Screws
 Use a wrench to twist off
the compressor/gas liquid
separator’s base nuts.
4. Remove the
compressor/gas liquid
separator from the chassis.
 Take away the
compressor/gas liquid
separator and replace with
a new one.
NOTE: When replacing
the compressor/gas liquid
separator, avoid touching
the nearby pipeline and
components.