Growatt SPH5000 Installation Manual

Chart 6.13
Note:
USB is only used for firmware update. Customer can’t use it for charging.
6.5.2 The SPH’s monitoring
The SPH provide RS232 interface. Users can through the following communication solution to monitor the SPH.
Note:
This kind of monitoring can only be used by the monitor of Growatt’s Shineserver /shine phone provided by
the company. Through RS232 interface connect to Wi-Fi-S/shinelink, use computer terminal/or mobile phone
for data monitoring.
Chart 6.17
Before use WIFI communication, you should make sure the follow PIN1 and PIN2 are ON:

Growatt SPH5000 Specifications

General

Model	SPH5000
Type	Hybrid Inverter
Rated Power	5000 W
Max. DC Voltage	550 V
Max. Output Current	22 A
Weight	25 kg
Max. DC Power	6000 W
Start Voltage	150 V
Nominal DC Voltage	360 V
Number of MPP Trackers	2
AC Nominal Power	5000 W
Max. AC Apparent Power	5000 VA
AC Nominal Voltage	230 V
AC Voltage Range	180-280V
Nominal Grid Frequency	50/60Hz
Total Harmonic Distortion (THDi)	<3%
Power Factor Adjustment Range	0.8 leading to 0.8 lagging
DC Injection Current	<0.5% In
Switching Time	<10 ms
Max. Charge/Discharge Power	5000 W
Max. Charge/Discharge Current	100 A
Protection degree	IP65
Max. PV Input Voltage	550 V
Cooling Method	Natural Convection
Communication with BMS	CAN
Operating Temperature Range	-25°C to 60°C
MPPT Voltage Range	120 V - 550 V