13 SWITCH OFF THE SCANNER
There are two ways to switch off the scanner:
1. In the microscope view, press Change slide > Shutdown.
Note: If you are preparing the scanner for transportation, remove the slide from the scanner before pressing
Shutdown.
OR
2. Press the power button.
During the shutdown, the power key blinks red. When the scanner is switched off, the power key shows a breathing
green light.
Important Notice: To prevent scanner damage, always switch off the scanner with above mentioned steps. Never
pull off the power cord without shutting down the scanner first. Sudden power loss can corrupt scanner’s internal
data storage and can potentially lead to data loss or scanner becoming unusable.
14 KEEP THE SOFTWARE UP TO DATE
From time to time, Grundium provides software updates. When a new update is available, you will get a notification
and instructions on how to update the software. Scanner intended usage flow must be verified after each software
update. This involves testing at least that the connectivity, scanning and exporting function properly.
15 CLEAN THE SCANNER
1. Switch off the scanner.
2. Remove the power cable and the network cable from the scanner.
3. Turn the focus knob until the camera lens is in the uppermost position.
4. Slide the topmost plate to the front and carefully remove the cover plate by pushing for example the
tip of a pen to the small hole under the right edge of the cover plate.
Note: when removing the cover plate, be careful not to damage any optics in the scanner.
To Next Page
Loading...