GW Instek GDM-834X Series - Configure Remote Control Interface; USB Interface

GDM-834X Series User Manual
102
Configure Remote Control Interface
USB Interface
The USB device port on the rear panel is used for remote control.
The USB port on the DMM will appear as a virtual COM port to a
connected PC. Any terminal program that can communicate via a
serial port can be used for remote control. Before the DMM can be
used for remote control the USB driver included on the User
Manual CD, must first be installed.
USB
configuration
PC connector
Type A, host
DMM connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed/high
speed)
Selectable baud rate
9600, 19200, 38400, 57600,
115200
Parity
None
Hardware flow
control
Off
Data Bits
8
Stop bit
1
Steps
1. Connect the USB cable to the rear panel type B
USB port.
2. Press MENU.
3. Go to I/O on level 1.
4. Go to USB on level 2.
5. Set the baud rate to an applicable rate.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com