GW Instek GDM-834X Series - GPIB Interface

REMOTE CONTROL
103
6. Press Enter to confirm the baud rate settings.
7. Press EXIT to exit from the USB menu.
Display
Baud rate
setting
Baud menu
indicator
GPIB Interface
In addition to the USB port, an optional GPIB port (GDM-8342
only) on the rear panel can be used for remote control.
GPIB
configuration
GPIB Address
Range
0~30
Steps
1. Connect the GPIB cable to the rear panel GPIB
port.
2. Press MENU.
3. Go to I/O on level 1.
4. Go to GPIB on level 2.
5. Turn GPIB ON and press Enter to Confirm.
6. The GPIB address settings will automatically
appear after turning GPIB on. Set the GPIB
address.
7. Press Enter to confirm the GPIB address setting.
8. Press EXIT to exit from the System menu.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com