GW Instek GDM-834X Series - Continuity Beeper Settings

GDM-834X Series User Manual
50
Continuity Beeper Settings
The beeper setting defines how the GDM-8342/8341 notifies the
continuity test result to the user.
Note: When the Beeper setting is off it will also turn off the keypad
tones as well as any error or warning tones.
Range
PASS
Beeps when the continuity passes.
FAIL
Beeps when the continuity fails.
OFF
Beeper is turned off.
Procedure
1. Press MENU.
2. Go to the SYSTEM menu on level 1
3. Go to the BEEP menu on level 2
4. Set the BEEP setting to PASS, FAIL or OFF.
5. Press the AUTO/ENTER key to confirm the
beeper settings.
6. Press EXIT to exit the BEEP setting menu.
Display
Beep
setting
Beep menu
indicator
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com