GW Instek GOM-805 - Configure GPIB Interface; RS232;USB Function Check

HANDLER/SCAN INTERFACE
93
Configure GPIB Interface
Background
The GPIB interface is SCPI-1994, IEEE488.1 and
IEEE488.2 compliant.
Note
The GPIB interface is only available on the GOM-804G
and GOM-805.
1. Select the
GPIB address
Configure the interface to GPIB and set
the GPIB address in
System>Utility>Interface menu.
Page 71
Connect one end of the
GPIB cable to the computer
and the other end to the
GPIB port on the
GOM-805.
GPIB
RS232/USB Function Check
Operation
Invoke a terminal application such as Realterm.
For RS-232, set the COM port, baud rate, stop bit, data
bit and parity accordingly.
To check the COM settings in Windows, see the Device
Manager. For example, in WinXP go to the Control panel
→ System → Hardware tab.
Run this query from the terminal.
*idn?
This should return the Manufacturer, Model number, and
Firmware version.
GWINSTEK,GOM805,GXXXXXXXX,V1.00
Note
If you are not familiar with using a terminal application
to send/receive remote commands from the serial port or
via a USB connection, please page 94 (Using Realterm to
Establish a Remote Connection) for more information.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com