GW Instek GPP-4323 - Standard Event Register Commands

GPP Series User Manual
188
Example
*SRE?
Returns “7”, which are the contents of the service
request enable register.
Command
*STB?
Function
Query the status byte register. This is the same as
performing a serial poll, however the master
summary bit (MSS, bit 6) will not be cleared by
the *STB command. The return value range is
from 0 to 255.
Example
*STB?
Returns 81 if the status byte register is set to 0101
0001.
Standard Event Register Commands
Command
*ESE<Allowed Values>
Function
Sets the standard event enable register. The
allowable value range is 0~255.
Example
*ESE 65
Sets the ESER as 0100 0001.
Command
*ESE?
Function
Queries the standard event enable register. It
returns are binary-weighted decimal value
representing all the enabled bits in the standard
event register.
Example
*ESE?
Returns 65, as the ESER is set as 0100 0001.
Command
*ESR?