GW Instek GPP-4323 - Page 197

APPENDIX
197
Series
regulation
Line： ≤ 0.01% + 5mV
Load：≤ 100mV
Ripple &
noise
≤1mVrms(5Hz-1MHz)
Resolution
Voltage
Current
Voltage: programming 1mV ,readback 0.1mV
Current: 0.1mA (1326: 0.2mA)
Accuracy
Ammeter
3.2A full scale (1326:6.2A)，programming 5
digits ，readback 5 digits
Voltmeter
33V full scale,programming 5 digits,readback 6
digits
Setting
accuracy
Voltage: ± (0.03% of reading + 10mV)
Current: ± (0.3% of reading + 10mA)
Readback
accuracy
Voltage: ± (0.03% of reading + 10mV)
Current: ± (0.3% of reading + 10mA)
Bindpost
Output
voltage
Output
current
1.8V/2.5V/3.3V/5.0V, ±5%
5A
CH3
(3323)
Line
regulation
≤ 3mV
Load
regulation
≤ 5mV
Ripple &
noise
≤ 2mVrms (5Hz - 1MHz)
Transient
recovery
time
≤ 100µs
(50% load change，minimum load 0.5A)
USB Port
Output
1.8V/2.5V/3.3V/5.0V, ±0.35V, 3A
Warning
The output current from the 2 terminals should Not
exceed 5A.
Load Mode
Display
Voltage
1-33.00V
Current
0-3.200A(1326:0-6.200A)
Power
0-50.00(1326:0-100.00W)
CV Mode
CH1/CH2
1.500V - 33.00V