GW Instek LCR-1100 - Front Panel Control Descriptions

GETTING STARTED
13
corresponding option located below
the LCD screen.
3
Measure
This key is used for entering the
measurement display area page.
4
System
This key is used for entering system
setup page.
5
Power
Press the power button for about 2
seconds, the instrument will turn on,
the green light of the power button
will be on, and the battery power is
used.
Press the power button for about 0.5s,
the instrument will shut down and the
button light will go out.
When the USB is inputting external
power, the power button lights up in
red and the external power is used.
6
Test Socket
Five-wire terminal test socket
7
Test Jack
Three-wire terminal test jack
8
Backlight
Local
Backlight brightness adjustment - 2
levels of backlight display, 50% and
100%
This key is also used as an unlock key
when the keypad is locked in remote
control.
9
Hold
When "H" is displayed on the display,
it means that the displayed value is
frozen.
10
Setup
This key is used to enter setup page.