GETTING STARTED
19
Connection of test terminal
The instrument has two kinds of test ports: five-terminal and three-
terminal test ports.
If you want to meet the accuracy specification of the instrument,
you must use the five-terminal test terminal, and the lower
accuracy of the three-terminal test will not guarantee the
specification.
1. Insert the plug of the test fixture vertically
into the five-terminal socket.
2. Move the plug of the test fixture to the right
and fix it in the center to avoid poor contact
during the test.
3. Removing the test fixture, first move the plug
of the fixture to the left, and then pull it out
upwards.
Figure
Connection of test
terminals
To Next Page
Loading...
