SETUP
29
BEEP
2 kinds of beep functions: qualified and bad beeps, which are used
to prompt the test results with beeps.
When powered by an external power source, the beep will beep
continuously until the status changes.
When on battery power, the beep will beep short until the status
changes.
Normally, if you want to enable the beep function, you should set
the beep to [Pass].
NOMINAL
If the COMP function is turned on, the nominal value needs to be
input before the formula can be calculated.
Input using the touch screen
keyboard
Use measurement standard
component value input
To Next Page
Loading...
