GW Instek LCR-6100 - Correction Subsystem; Correction:open; Figure 11-10 Correction Subsystem Command Tree

Command Reference
118
Parameter
Where,<n> is:
n NR1(1 to 10): List sweep point
Query Response
{on,off},<point value>,{A,B,-
},<NR3:low>,<NR4:high>
Example
SEND> LIST:BAND? 1<NL>
RET> on,1.00000e+03,A,1.000000E-9,2.000000E-
9<NL>
11.13 CORRection Subsystem
The CORRection subsystem command group sets the correction function,
including the OPEN, SHORT and LOAD correction settings.
Note
The CORRection subsystem CANNOT work in
[LIST MEAS] page.
Figure 11-10 CORRection Subsystem Command Tree
11.13.1 CORRection:OPEN
The CORRection:OPEN command execute all preset OPEN correction data
measurement points.
Command
Syntax
CORRection:OPEN
Example
SEND> CORRection:OPEN<NL>
CORRection
:
OPEN
:
STATe
:
SHORt
STATe:
{ON, OFF}
:
SPOT
STATe:
FREQuency:
OPEN:
SHORt:
{ON, OFF}
{ON, OFF}
<n>,<value>
<n>
<n>